0 Replies Latest reply on Jun 14, 2016 4:14 PM by Joe Onley

    Placed a 96 Count Fiber Feature BEGIN to END; At END placed a Customer Prem (CPE) device to enable tracing; Traced 1 foot, and then realized CPE should have been placed at cable BEGIN;Disconnected CPE at END and deleted Placed CPE at BEGIN and connected t

    Joe Onley

      Placed a 96 Count Fiber Feature BEGIN to END

      At END placed a Customer Prem (CPE) device to enable tracing

      Traced 1 foot, and then realized CPE should have been placed at cable BEGIN

      Disconnected CPE at END and deleted

      Placed CPE at BEGIN and connected to Blue/Blue

      When I do a trace the TRACE initializes and traces at END   ?????to be absolutely clear, if you trace 500’ at BEGIN CPE the trace appears at END, with a pink trace color dot at the beginning???

       

      Did lots of Undo and started again, same result

      Closed Session and restarted session, same result

      Closed Program Restarted Program, and ECW Version Error that is supposed to be reported to ERDAS