2 Replies Latest reply on Jun 10, 2016 7:41 AM by Luis Sanchez

    I got a question:  An open switch between two circuits (feeders) should have the bit multi feed in the feederinfo field set to one (10000000) or zero?  I think it should be 1.  Thank you.  Luis

    Luis Sanchez

      If a open switch is in the boundaries of two circuits, the feederid and feederid2 have two different values.
      I checked in our system and most of them have the bit for multi feed set to 1; but a few switches are set to 0.   I think the ones set to 0 are bad but not 100% sure.

      Please somebody in support to answer this question.

      Thank you,

      Luis